code composer studio download code from msp430

I tried to get the 3.3V supply voltage for the downloading purposes from the MSP-FET (JTAG pin 2) and it still doesn't work and get the same error. It is needed to be said that when i hit on the download button the 'MODE' red led on the MSP-FET flashes and then stays on after the error message has been popped. 'Tue 11:08:46: Fatal error: Could not find device (or device not supported) Session aborted! ' I tried to do the same in IAR Embedded Workbench (Same code, same properties) it asks me to update my firmware of the MSP-FET i click ok and it updates the firmware, but then i get the same error as i have got in the Code Composer Studio :

'Error connecting to the target: Unknown device'. My problem occurs when i try to download the program to the MSP430 device, when i hit on the downloading button an error message pops up : I didn't connect the TEST/VPP and didnt connect the the resistor R2 330Ohms as instructed in that datasheet coz i dont need to use the fuse blow protection functionality. (The board supplies the 3.3V so i connected it to pin 4 in the JTAG connector of the MSP-FET). Then i connected the MSP-FET to the board according to the datasheet SLA138H, page 26.

I compiled the program and no errors has found. I have written a code in Code Composer Studio (Defined the properties of CCS's project to the devices im using). I also use a MSP-FET Emulator in order to program that device. I'm using MSP430F5131 Microcontroller of TI.

Code composer studio download code from msp430